Leak detection
Ramadan Drain CleaningWater tank leaks in Sabhan Industrial
Water tank leak detection in Sabhan Industrial focuses on large storage tanks in factories and warehouses. Sabhan is an industrial zone with workshops and production lines that use heavy water volumes, and a single tank can hold a thousand litres or far more, so even a small loss means real economic waste.
Where to start
Where the levelis going.
Four signs that separate a leaking tank from the rest.
01
It drops with nobody using it
Mark the level at night and look at it in the morning before anyone uses water. A clear drop with no use means water is leaving the tank or a pipe off it, not being consumed.
02
Damp on the wall below
A line of damp or white salt running down the roof wall under the tank says water is leaving the tank or a fitting on it. A ground tank shows the same trace on the paving around it.
03
The overflow runs all day
If the overflow pipe is running while you are not filling, the float valve is not closing and the tank keeps filling and throwing it away. That is a real loss on the bill, but it is not a hole in the tank.
04
The pump fills more than usual
A pump that runs more often than it used to on the same usage says water is going missing between filling and using it, either in the tank or on the line after it.
This area
What setsthis area apart
Tanks in Sabhan factories are usually steel boxes on reinforced concrete pads or elevated on steel frames. Pipes are visible and run across the ground or sit on metal channels, making visual inspection and listening for hisses or drips straightforward. The tank itself may be painted or exposed to coastal moisture, so rust and fine perforations develop over time. We inspect all top, bottom and side joints and seams before we pinpoint the exact leak location.
Sabhan Industrial sits in Mubarak Al-Kabeer governorate, a factory and production zone that relies on large water storage tanks.
Industrial tanks in Sabhan are typically exposed to coastal air and moisture, which accelerates rust and corrosion.
The service
On the tank,in detail.
Service
Leak detection on water tanks and their outlets
Tank types
Plastic roof tanks and concrete ground tanks
We also check
The float valve, the overflow, outlet fittings and the pump valve
Method
A level test with the outlets isolated, then fittings and body
Coverage
Houses, chalets, blocks and complexes, across Kuwait
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we check
From the mark tothe cause.
Four steps, each one taking a possible cause off the list.
We mark the level and close the outlets
We mark the water level on the tank body and close the inlet and outlet valves, so the tank is shut and nothing can enter or leave it.
We read the level again
If the level drops while the tank is closed on both sides, the loss is in the tank body itself or in a fitting below the water line.
We open the outlets one at a time
If the level held while it was closed and dropped once the outlet was opened, the tank is sound and the loss is on the line after it, which is a pipework job.
We check the body and fittings
We go over the seams, the corners, the area round the outlet boss and the base, then the float valve and the overflow, and tell you the cause and what it needs.
Common questions
Questions about Water tank leaks in Sabhan Industrial
We shut off the inlet valve to the tank for an hour and watch the level. If it drops without anyone drawing water, the leak is definitely in the tank or the outlet pipes.
Pipe fittings are repaired easily by replacing the washer or the coupling entirely. If the tank body itself has a hole, you need a new tank or a temporary seal. The cost and time difference is substantial.
Nearby areas
More areas for Water tank leaks
Same service, in nearby areas.
Other services
Other services in Sabhan Industrial
Other work we do in the same area.