Leak detection
Ramadan Drain CleaningWater tank leaks in Rai Industrial
Water tank leak detection in Rai Industrial focuses on large tanks running high pressure to feed workshops and industrial buildings. Rai Industrial is a zone of factories, workshops and warehouses, with massive tanks and long pipework, so a small leak may go unnoticed for weeks.
Where to start
Where the levelis going.
Four signs that separate a leaking tank from the rest.
01
It drops with nobody using it
Mark the level at night and look at it in the morning before anyone uses water. A clear drop with no use means water is leaving the tank or a pipe off it, not being consumed.
02
Damp on the wall below
A line of damp or white salt running down the roof wall under the tank says water is leaving the tank or a fitting on it. A ground tank shows the same trace on the paving around it.
03
The overflow runs all day
If the overflow pipe is running while you are not filling, the float valve is not closing and the tank keeps filling and throwing it away. That is a real loss on the bill, but it is not a hole in the tank.
04
The pump fills more than usual
A pump that runs more often than it used to on the same usage says water is going missing between filling and using it, either in the tank or on the line after it.
This area
What setsthis area apart
Tanks in Rai Industrial sit either on very high roofs or ground-level beside the workshop. Pipes from the tank run through steel ceilings and concrete walls, and each joint is a potential leak point. Workshop pressure equipment needs clean water with no air leaks, so any tank seepage affects production.
Rai Industrial sits in Farwaniya governorate, a zone zoned for industry and workshops with massive water tanks feeding factories and facilities.
Rai Industrial tanks need regular scheduled checks because high line pressure accelerates joint and fitting wear.
The service
On the tank,in detail.
Service
Leak detection on water tanks and their outlets
Tank types
Plastic roof tanks and concrete ground tanks
We also check
The float valve, the overflow, outlet fittings and the pump valve
Method
A level test with the outlets isolated, then fittings and body
Coverage
Houses, chalets, blocks and complexes, across Kuwait
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we check
From the mark tothe cause.
Four steps, each one taking a possible cause off the list.
We mark the level and close the outlets
We mark the water level on the tank body and close the inlet and outlet valves, so the tank is shut and nothing can enter or leave it.
We read the level again
If the level drops while the tank is closed on both sides, the loss is in the tank body itself or in a fitting below the water line.
We open the outlets one at a time
If the level held while it was closed and dropped once the outlet was opened, the tank is sound and the loss is on the line after it, which is a pipework job.
We check the body and fittings
We go over the seams, the corners, the area round the outlet boss and the base, then the float valve and the overflow, and tell you the cause and what it needs.
Common questions
Questions about Water tank leaks in Rai Industrial
We shut off the tank valve from the pipes entirely for an hour and watch the level. If it still drops, the leak is in the tank. If it holds, the leak is downstream in the pipework.
Yes, because a workshop loses productivity every minute without pressure water. We prioritise Rai Industrial work and the check is more thorough because pressure equipment is sensitive.
Nearby areas
More areas for Water tank leaks
Same service, in nearby areas.
Other services
Other services in Rai Industrial
Other work we do in the same area.