Leak detection
Ramadan Drain CleaningWater tank leaks in Julaiaa
Water tank leak detection in Julaiaa starts by inspecting the roof tank and the line that feeds water up from below. Julaiaa is a residential area in southern Ahmadi with a mix of modern villas and older apartment blocks. New tanks have protection systems, but old flats have basic tanks and leaks hide because the riser runs inside the wall.
Where to start
Where the levelis going.
Four signs that separate a leaking tank from the rest.
01
It drops with nobody using it
Mark the level at night and look at it in the morning before anyone uses water. A clear drop with no use means water is leaving the tank or a pipe off it, not being consumed.
02
Damp on the wall below
A line of damp or white salt running down the roof wall under the tank says water is leaving the tank or a fitting on it. A ground tank shows the same trace on the paving around it.
03
The overflow runs all day
If the overflow pipe is running while you are not filling, the float valve is not closing and the tank keeps filling and throwing it away. That is a real loss on the bill, but it is not a hole in the tank.
04
The pump fills more than usual
A pump that runs more often than it used to on the same usage says water is going missing between filling and using it, either in the tank or on the line after it.
This area
What setsthis area apart
Julaiaa has two closely-spaced building types: modern villas with roof tanks and visible pipes plus smart overflow valves, and older apartment blocks right next door with shared drain lines and basic tanks without individual meters. In an old flat, the leak may be in the riser pipe hidden inside the wall, visible only when we strip plaster or find dampness on the ceiling of the flat below. The shared line between flats makes it harder to tell if the leak is in your tank or in the common riser.
Julaiaa sits in southern Ahmadi, a residential area with varied tank types across older and newer flats and villas.
Old flats in Julaiaa share the main drain line, making leaks in hidden risers hard to pinpoint from one unit alone.
The service
On the tank,in detail.
Service
Leak detection on water tanks and their outlets
Tank types
Plastic roof tanks and concrete ground tanks
We also check
The float valve, the overflow, outlet fittings and the pump valve
Method
A level test with the outlets isolated, then fittings and body
Coverage
Houses, chalets, blocks and complexes, across Kuwait
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we check
From the mark tothe cause.
Four steps, each one taking a possible cause off the list.
We mark the level and close the outlets
We mark the water level on the tank body and close the inlet and outlet valves, so the tank is shut and nothing can enter or leave it.
We read the level again
If the level drops while the tank is closed on both sides, the loss is in the tank body itself or in a fitting below the water line.
We open the outlets one at a time
If the level held while it was closed and dropped once the outlet was opened, the tank is sound and the loss is on the line after it, which is a pipework job.
We check the body and fittings
We go over the seams, the corners, the area round the outlet boss and the base, then the float valve and the overflow, and tell you the cause and what it needs.
Common questions
Questions about Water tank leaks in Julaiaa
It could be your tank, the flat above you, or the shared line. We check your roof, inspect the tank and the pipes coming down above your ceiling. Then we ask upstairs neighbours to open their tanks so we can rule them out.
If the shared line between flats is leaking, repair is the responsibility of all residents or the building management. We can confirm the leak is in the common riser and not your tank, then management can call in their workers.
Nearby areas
More areas for Water tank leaks
Same service, in nearby areas.
Other services
Other services in Julaiaa
Other work we do in the same area.