Leak detection
Ramadan Drain CleaningWater tank leaks in Jahra Industrial
Water tank leak detection in Jahra Industrial targets large production tanks in factories and processing plants. Jahra Industrial is a developed industrial zone with major factories and workshops, and tanks there serve continuous production, so any loss or leak affects output and costs.
Where to start
Where the levelis going.
Four signs that separate a leaking tank from the rest.
01
It drops with nobody using it
Mark the level at night and look at it in the morning before anyone uses water. A clear drop with no use means water is leaving the tank or a pipe off it, not being consumed.
02
Damp on the wall below
A line of damp or white salt running down the roof wall under the tank says water is leaving the tank or a fitting on it. A ground tank shows the same trace on the paving around it.
03
The overflow runs all day
If the overflow pipe is running while you are not filling, the float valve is not closing and the tank keeps filling and throwing it away. That is a real loss on the bill, but it is not a hole in the tank.
04
The pump fills more than usual
A pump that runs more often than it used to on the same usage says water is going missing between filling and using it, either in the tank or on the line after it.
This area
What setsthis area apart
Industrial tanks in Jahra Industrial are massive, usually on heavy concrete pads or metal frameworks. Pipes are numerous and run to different production machinery, often large diameter. A small leak is invisible to the eye but over time wastes thousands of litres. We use listening, visual inspection and valve-by-valve testing to find the one leaking pipe among many. The tank itself endures heavy use and pressure, so cracks or weld weakness can develop.
Jahra Industrial sits in Jahra governorate, a developed industrial zone with advanced factories and production lines dependent on large water storage.
Industrial tanks in Jahra are typically equipped with metering and monitoring systems, but sensors may not catch slow leaks.
The service
On the tank,in detail.
Service
Leak detection on water tanks and their outlets
Tank types
Plastic roof tanks and concrete ground tanks
We also check
The float valve, the overflow, outlet fittings and the pump valve
Method
A level test with the outlets isolated, then fittings and body
Coverage
Houses, chalets, blocks and complexes, across Kuwait
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we check
From the mark tothe cause.
Four steps, each one taking a possible cause off the list.
We mark the level and close the outlets
We mark the water level on the tank body and close the inlet and outlet valves, so the tank is shut and nothing can enter or leave it.
We read the level again
If the level drops while the tank is closed on both sides, the loss is in the tank body itself or in a fitting below the water line.
We open the outlets one at a time
If the level held while it was closed and dropped once the outlet was opened, the tank is sound and the loss is on the line after it, which is a pipework job.
We check the body and fittings
We go over the seams, the corners, the area round the outlet boss and the base, then the float valve and the overflow, and tell you the cause and what it needs.
Common questions
Questions about Water tank leaks in Jahra Industrial
We close all outlet valves from the tank and watch the level for an hour. If it drops, the leak is in the tank itself or main pipes before the valves. If it does not drop, the problem is in machinery or pipes after the valves.
If the leak is one drop per second, that is around forty litres daily or a thousand litres monthly. It might not sound like much, but yearly the cost is catastrophic. We trace the leak quickly to protect the factory.
Other services
Other services in Jahra Industrial
Other work we do in the same area.