Heater or plumbing
When the fault isthe heater.
Before you call, these signs tell you whether the fault sits in the heater itself or out in the pipework.
01
Cold at every tap
If the hot water goes at all the bathrooms and the kitchen together, one thing feeds them all and that is the central heater. One cold bathroom with the rest still hot is a mixer or a branch, not the cylinder.
02
The breaker keeps tripping
A breaker that drops every time the heater switches on is not a house wiring fault. The element sheath has failed and is letting current into the water, so the answer is a new element, not pushing the switch back up.
03
It runs out early
The cylinder gives less hot water than it used to before it turns cold. Scale settles out of Kuwaiti water and builds on the tank floor, taking up volume inside it, so the usable draw is smaller than the tank was built for.
04
Water under the heater
Water on the floor under a heater is either a pipe joint or the body of the cylinder itself. A joint is remade. A weep from the tank body means the steel has gone through and the heater is replaced, not repaired.
This area
What setsthis area apart
Watiya is an older district near the old city walls, with a mix of small villas and low-rise residential blocks, and most heaters are mounted on roof spaces or in small service rooms off the hallway. Villa roofs sit low and passages are tight, so we need to know exactly where the heater sits before we navigate the narrow stairs. The old steel pipework around the heater corrodes slowly, and the harsh Gulf sun affects the pipe metals and the cylinder body itself.
Watiya is an older residential district in Kuwait governorate, close to the historic walls of the old city.
Most heaters in Watiya are mounted on low villa roofs or in narrow passages where there is little working space.
At a glance
Heaters, in short.
Field
Central water heater repair, servicing and installation
Heater type
Central cylinders in houses, flats and chalets
What it covers
Elements, thermostats, flushing and descaling, and new installs
Coverage
All six governorates and every area inside them
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the call tohot water.
The same order on any heater, whether the job turns out to be a repair, a flush or a new fit.
You describe it on the call
Tell us whether the heater is stone cold or just weak, when it changed, and whether the breaker drops. Those three answers decide between an element, a thermostat and a flush.
We isolate power and water
The heater breaker goes off and the cold feed valve is closed before anything is opened. No cover comes off a live element and no thermostat is touched while the cylinder is under pressure.
We test before we swap
We read the element and thermostat terminals and look at the state of the tank inside, then tell you exactly what has failed before any part is changed.
We refill, vent and test
The cylinder is filled and the air bled off at the highest hot tap before the power goes back on, then we run a hot tap in front of you and watch it hold its temperature.
Common questions
Questions about Water heaters in Watiya
A full inspection first, we clean the cylinder of sediment and check the metals and valves. If the heater is over ten years old and corrosion is visible, you likely need replacement not repair.
Same location as the old one because the copper and steel pipes are already connected there, we cannot disconnect them. In some Watiya villas the heater sits on the roof, in others in the hallway or service room, we install the new one in that exact spot.
Nearby areas
More areas for Water heaters
Same service, in nearby areas.
Other services
Other services in Watiya
Other work we do in the same area.