Water heaters
Ramadan Drain CleaningWater heaters in Sharq
Water heater repair in Sharq is trickier because many older flats here were built without enough ceiling space for a large central cylinder. Sharq is a mixed commercial and tourist area near the towers and marina, and most flats need a heater sized properly for the number of units and the high water pressure.
Heater or plumbing
When the fault isthe heater.
Before you call, these signs tell you whether the fault sits in the heater itself or out in the pipework.
01
Cold at every tap
If the hot water goes at all the bathrooms and the kitchen together, one thing feeds them all and that is the central heater. One cold bathroom with the rest still hot is a mixer or a branch, not the cylinder.
02
The breaker keeps tripping
A breaker that drops every time the heater switches on is not a house wiring fault. The element sheath has failed and is letting current into the water, so the answer is a new element, not pushing the switch back up.
03
It runs out early
The cylinder gives less hot water than it used to before it turns cold. Scale settles out of Kuwaiti water and builds on the tank floor, taking up volume inside it, so the usable draw is smaller than the tank was built for.
04
Water under the heater
Water on the floor under a heater is either a pipe joint or the body of the cylinder itself. A joint is remade. A weep from the tank body means the steel has gone through and the heater is replaced, not repaired.
This area
What setsthis area apart
Flats in Sharq range from brand new to 1970s and 80s builds, and central cylinders work under high pressure from the main supply from day one. Older flats have aged pipework that needs careful inspection before we fit a replacement, as the inside of the pipes may be heavily corroded. We check flanges, springs and isolation valves closely, because any fault raises hot water pressure to unsafe levels.
Sharq sits in Kuwait governorate, a mixed commercial and residential area with multi-storey flats and hotels.
Water pressure in Sharq is higher than in other areas, so cylinders here face greater stress on valves and seals.
At a glance
Heaters, in short.
Field
Central water heater repair, servicing and installation
Heater type
Central cylinders in houses, flats and chalets
What it covers
Elements, thermostats, flushing and descaling, and new installs
Coverage
All six governorates and every area inside them
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the call tohot water.
The same order on any heater, whether the job turns out to be a repair, a flush or a new fit.
You describe it on the call
Tell us whether the heater is stone cold or just weak, when it changed, and whether the breaker drops. Those three answers decide between an element, a thermostat and a flush.
We isolate power and water
The heater breaker goes off and the cold feed valve is closed before anything is opened. No cover comes off a live element and no thermostat is touched while the cylinder is under pressure.
We test before we swap
We read the element and thermostat terminals and look at the state of the tank inside, then tell you exactly what has failed before any part is changed.
We refill, vent and test
The cylinder is filled and the air bled off at the highest hot tap before the power goes back on, then we run a hot tap in front of you and watch it hold its temperature.
Common questions
Questions about Water heaters in Sharq
The thermostat might be oversensitive to temperature swings, or the mixing valve is partially blocked. We open the heater and check the thermostat and isolation valve to rule out underground pipe issues.
If the tank is over ten years old and has significant corrosion or leaks, replacement is often cheaper than repair. But if only the valve or thermostat is faulty, repair keeps the cost down.
Nearby areas
More areas for Water heaters
Same service, in nearby areas.
Other services
Other services in Sharq
Other work we do in the same area.