Water heaters
Ramadan Drain CleaningWater heaters in Rai Industrial
Water heater repair, installation and ongoing servicing for commercial and residential buildings in Rai Industrial is constant work. Rai Industrial is a mixed zone with warehouses, residential blocks and office towers near The Avenues Mall, and each building's central heater runs under heavy load.
Heater or plumbing
When the fault isthe heater.
Before you call, these signs tell you whether the fault sits in the heater itself or out in the pipework.
01
Cold at every tap
If the hot water goes at all the bathrooms and the kitchen together, one thing feeds them all and that is the central heater. One cold bathroom with the rest still hot is a mixer or a branch, not the cylinder.
02
The breaker keeps tripping
A breaker that drops every time the heater switches on is not a house wiring fault. The element sheath has failed and is letting current into the water, so the answer is a new element, not pushing the switch back up.
03
It runs out early
The cylinder gives less hot water than it used to before it turns cold. Scale settles out of Kuwaiti water and builds on the tank floor, taking up volume inside it, so the usable draw is smaller than the tank was built for.
04
Water under the heater
Water on the floor under a heater is either a pipe joint or the body of the cylinder itself. A joint is remade. A weep from the tank body means the steel has gone through and the heater is replaced, not repaired.
This area
What setsthis area apart
Buildings in Rai Industrial are of two types: older residential blocks and new towers, each with a central heater system of different specs. New towers have large heaters, strong pumps and complex distribution lines, while older heaters have weaker anodes and pipes starting to corrode. We inspect the whole area around the heater, remove sediment, test the pressure and temperature, and check the valves near the cylinder.
Rai Industrial sits in Farwaniya governorate, a mixed zone with residential and commercial buildings adjacent to The Avenues Mall.
Most heaters in the newer towers and blocks of Rai Industrial are mounted in sealed plant rooms with electronic control boards.
At a glance
Heaters, in short.
Field
Central water heater repair, servicing and installation
Heater type
Central cylinders in houses, flats and chalets
What it covers
Elements, thermostats, flushing and descaling, and new installs
Coverage
All six governorates and every area inside them
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From the call tohot water.
The same order on any heater, whether the job turns out to be a repair, a flush or a new fit.
You describe it on the call
Tell us whether the heater is stone cold or just weak, when it changed, and whether the breaker drops. Those three answers decide between an element, a thermostat and a flush.
We isolate power and water
The heater breaker goes off and the cold feed valve is closed before anything is opened. No cover comes off a live element and no thermostat is touched while the cylinder is under pressure.
We test before we swap
We read the element and thermostat terminals and look at the state of the tank inside, then tell you exactly what has failed before any part is changed.
We refill, vent and test
The cylinder is filled and the air bled off at the highest hot tap before the power goes back on, then we run a hot tap in front of you and watch it hold its temperature.
Common questions
Questions about Water heaters in Rai Industrial
The thermostat might be faulty or the anode could be corroded and spent. We check the sacrificial anode first, because it protects the heater from rust, and if it is gone we replace it with a new one.
If the hot water output drops or weakens, or you hear strange noises from the heater, it needs work. We check the sediment at the bottom, the pipes and the anode.
Nearby areas
More areas for Water heaters
Same service, in nearby areas.
Other services
Other services in Rai Industrial
Other work we do in the same area.