Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Wafra is an old agricultural cooperative with hundreds of small and medium plots, each with its own small or medium valve. Main irrigation lines feed water from a single source, and individual valves control the flow to each farm. Water goes directly to soil, so sediment and clay enter the lines and block valves. Old Wafra valves may be simple iron and rust quickly from moisture exposure. If a plot valve fails, the farmer loses control of irrigation amount, and the crop may suffer.
Wafra sits in Ahmadi governorate, a cooperative farming area near the Saudi border.
Wafra farm valves are small compared to factory or port valves, but irrigation silt clogs them quickly.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Wafra
Silt and sediment from irrigation water enter the valve and clog it. Some valves are very old with rusted iron, so they will not open or close properly. We inspect it, clean it, or replace it depending on its condition.
Yes, irrigation water carries sediment and soil, but house water is treated and clean. Wafra farm valves need regular silt cleaning, whereas house valves do not require that level of maintenance.
Nearby areas
More areas for Valve repair
Same service, in nearby areas.
Other services
Other services in Wafra
Other work we do in the same area.