Valve symptoms
When a valveneeds work.
A valve is a part that sits still, which is why you discover its fault at the worst moment.
01
Closed, and water still comes
You turn the handle until it stops and it feels shut, but the tap still gives a thin flow. That means the closing part inside no longer meets its seat fully, because of deposits or wear.
02
Seized and will not turn
A valve nobody has turned for a long stretch sticks as deposits build around the spindle. Forcing it snaps the handle or opens the spindle up, and you end up with a leak where there was none.
03
A weep at the handle
A drop appearing around the spindle when you open or close it. The packing that seals the spindle has tired, and that is often repaired without changing the whole valve if the body is sound.
04
The fixture has no valve
A basin, a toilet or a washing machine with no valve of its own means any small repair stops water to the whole house. Fitting an angle valve to each fixture changes every future repair.
This area
What setsthis area apart
Old Jahra houses near the Old Market and Red Fort area are older flats or small villas built four decades ago. Copper and steel pipes are discoloured by water deposits and rust, and the original shutoffs may be just as old and frozen solid. Some houses have extra intermediate valves or old above-ground extensions buried under paint and plaster. When we loosen an old valve, the corroded pipe itself might snap.
Old Jahra is an established residential district in Jahra governorate near the Old Market and Red Fort, with most houses built over four decades ago.
Old Jahra pipes are mostly copper and galvanised steel, and original valves in them may be rusted solid and immovable.
In short
The valve work.
Service
Water valve repair, replacement and fitting
Types
Main valves, branch valves, angle valves at fixtures
Where they sit
At the tank, on the roof, in the yard, under fixtures
Where it applies
Houses, flats, blocks, complexes and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
From above itto below it.
Changing a valve needs another valve above it, and that is the first thing we confirm.
We find the upstream shut off
We look for a valve able to stop the water before the failed one, and if there is none we shut off at the tank outlet or the supply point itself.
We drain before opening
The lowest tap on the run is opened so whatever is left in the pipework drains out, because unscrewing a valve on a full line soaks the area and makes the work harder.
We repair or replace
If the weep is only at the spindle and the body is sound, the packing is renewed. If the closing part is worn or the body is tired, a new valve goes in its place.
We open and close it twice
Pressure comes back and the valve is opened and closed several times with a tap watched after it, because a valve that works once does not necessarily close properly the next time.
Common questions
Questions about Valve repair in Jahra (Old)
We apply a penetrating oil and let it soak before trying the wrench. If it will not budge, we may need to cut the pipe and replace both the valve and a section of the line.
Rust usually comes from the old pipes themselves or sediment inside them, though occasionally the valve is the source. We check both and trace where the rust originates.
Other services
Other services in Jahra (Old)
Other work we do in the same area.