Plumbing and sanitary
Ramadan Drain CleaningShower cabin installation in Anjafa
Shower cabin installation in Anjafa starts by reviewing the floor and waste, because buildings here are old, over thirty years, and bathrooms are tight. The tray base needs waterproofing and cement underneath to ensure correct fall and prevent water spilling outside.
Leak signs
When water escapesthe cabin.
Water getting out has four known routes.
01
Wet tiles outside the cabin
Wet floor after every shower means water is escaping at the seal along the tray edge or under the door threshold. The glass itself is rarely the cause.
02
The tray flexes underfoot
If the tray gives under you when you stand on it, it is not fully supported underneath. That constant flex opens the seal around it and works the waste connection loose.
03
The door drags or will not shut
A door catching on the floor or not closing tightly means the profile was fitted out of square or the tray is not level. A door that does not close lets water out of the gap every time it is used.
04
The waste is slow
Water standing in the tray after the shower is off means the waste below has not enough fall, or its trap is packed with hair and soap. Standing water finds another way out.
This area
What setsthis area apart
Anjafa is an older residential area throughout, with most buildings five or six storeys and flats inside. Bathrooms are very tight and some floors are damp or uneven from age. We measure the bathroom first, and the cabin may require removing existing tiles or trimming wall sections because space is limited. The waste runs either deep under the floor or from old structural foundations, so we test drain speed before fitting the final frame.
Anjafa sits in Hawalli governorate, an older residential area with multiple multi-storey apartment blocks.
Most Anjafa flats were built before the 1980s, and the original drainage runs are thick-walled and may be partially blocked.
In short
The cabin work.
Service
Shower cabin installation and leak repair
Included
Tray, waste and trap, profiles, door, sealing
Types
Complete cabins, and glass enclosures on a separate tray
Where it applies
Bathrooms in houses, flats and chalets
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From the trayto the door.
Bottom upwards, and each stage is tested before the next one starts.
We set the waste first
The waste outlet and its fall are checked first, and we confirm the tray trap sits comfortably beneath, because a tray fitted over a bad waste comes up again.
We support and level the tray
The tray is fully supported underneath and levelled, so it cannot flex under weight and falls slightly towards the waste so water leaves on its own.
We fit profiles and glass
The profiles are fixed to the wall truly vertical, because any lean in them shows up in the door at once and makes it drag or refuse to close.
We test before sealing
The shower runs, the water is left to move, and the floor around the cabin is watched. Only then does the silicone bead go on, on the inside.
Common questions
Questions about Shower cabin installation in Anjafa
The new cabin does not fix the underlying damp problem, but correct drainage and ventilation after installation reduce moisture. You must ensure ventilation works and check for leaks under the floor.
Possibly, but we choose a very compact size or fit a narrow hinged door. Precise measurement and choice from limited sizes only.
Nearby areas
More areas for Shower cabin installation
Same service, in nearby areas.
Other services
Other services in Anjafa
Other work we do in the same area.
Back to Shower cabin installation