Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Uyoun
Sanitary fixture installation in Uyoun means taps, sinks and toilets, each needing a solid fixing point, pressured water supply, and a waste outlet at the correct height. Uyoun sits near the natural springs area in Jahra, and its buildings are a mix of older villas and apartment blocks.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Older neighbourhoods in Uyoun have many small flats and mid-sized villas with walls that are weaker because of older construction. When we fit a sink or shower, we tap-test the wall first and check there is enough depth behind the tiles for fixings. Old water lines in the area need pressure testing before we connect a new tap, and inspection chambers near some flats sit deeper, so we may need to raise the waste outlet height.
Uyoun sits in Jahra governorate, a residential area near the natural springs zone, with a mix of older and newer buildings.
Most flats in Uyoun were built many years ago, and the original pipes are narrow and may need replacement if you add new fixtures.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Uyoun
Old lines in Uyoun have mineral deposits and rust coating the pipe walls, which reduces pressure. We check the line from the street and see if we need to replace a section of pipework before installation.
If the wall is strong enough and the waste outlet is positioned right, we fit it from outside without breaking tile. But if the tiles are on old render or the wall has gaps, we may need to open a small section.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Uyoun
Other work we do in the same area.
Back to Sanitary fixture installation