Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Qosor
Sanitary fixture installation in Qosor requires precise alignment of three parts: the mounting surface, the water supply from the pipe, and the waste draining at the right height. Qosor is a residential area south of Mubarak Al-Kabeer with relatively new villas and flats, and fixing is faster and easier because the lines are standard.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Qosor has villas and apartment blocks built recently, newer than Masayel. Walls are standard block and underground lines are organized and easy to access. Villas need standard fixing to block walls, and flats need more precision because of shared walls and insulation. When installing a new fixture in Qosor, the existing line is properly arranged, so we fix quickly without needing line clearing or floor repair. The height is standard, so no worry about blockage or poor fall.
Qosor is a modern residential area in southern Mubarak Al-Kabeer governorate with villas and flats on organized and standard waste lines.
Qosor lines follow modern standards with uniform heights, so installation is faster than older areas.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Qosor
Flat fixing is more precise but not harder. Villa walls are thicker, but we must respect shared walls and insulation in flats. Both have standard lines, so the work is fast if the line is clear.
Yes, the new lines are standard and have sufficient pressure. We check pressure during installation and testing, and if there is an issue we locate it fast. Flats typically need less pressure than villas, and Qosor has no problem.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Qosor
Other work we do in the same area.
Back to Sanitary fixture installation