Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Qasr
Sanitary fixture installation in Qasr means linking three things exactly right: a strong wall to fix to, one or two water lines, and a waste outlet at the right height. Qasr is a residential area in Jahra with mid-size flats and small villas close together.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Most Qasr flats are in residential blocks built twenty years ago or more, with relatively thin walls and water pipes cast into concrete. Small villas in the same area have layouts more like flats than large houses, so bathroom and kitchen may sit next to each other. When we fit fixtures, we check old pipes carefully because they may carry high pressure, and we test for leaks before we install the new fitting.
Qasr is a residential area in Jahra governorate with closely-spaced flats and small villas.
Water pipes in Qasr flats serve one or two floors at most, so pressure is relatively high compared to taller blocks.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Qasr
Old pipes may have small leaks or uneven pressure, which damages a new fixture or reduces its flow. We check them with a pressure gauge before we connect the new tap.
If pressure is low throughout the flat, the issue is usually the main riser or the street supply. If only one tap is low, we can fit a regulator or replace narrow pipes.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Qasr
Other work we do in the same area.
Back to Sanitary fixture installation