Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Ali Sabah Al-Salem
Sanitary fixture installation in Ali Sabah Al-Salem needs care because houses are near the sea and humidity is high. Ali Sabah Al-Salem is a modern coastal suburb in Ahmadi, and sanitary fixtures face corrosion from the salt environment.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Ali Sabah Al-Salem houses are modern villas and a few apartment towers, most built in recent years to high construction standards. The coastal environment means pipes and taps rust faster than in inland suburbs, so we use copper or strong PVC plastic pipe and avoid plain steel. Many villas in the area have a private beach or garden facing the coast road, and pipes run deeper underground to avoid salt exposure.
Ali Sabah Al-Salem sits in Ahmadi governorate, a modern coastal area near Ali Sabah Al-Salem Co-op on the sea.
Copper pipes near the seafront in Ali Sabah Al-Salem need a protective coating or wrapping to stop salt from damaging them.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Ali Sabah Al-Salem
Cheap fixtures are often made from materials that can't resist salt. You need brass or rust-resistant fixtures to last longer in Ali Sabah Al-Salem.
Yes, if the pipes are copper, we coat them with a protective layer or wrap them in insulating tape. This extends the pipe life by years in a salty environment.
Other services
Other services in Ali Sabah Al-Salem
Other work we do in the same area.
Back to Sanitary fixture installation