Plumbing and sanitary
Ramadan Drain CleaningSanitary fixture installation in Abu Hasaniya
Sanitary fixture installation in Abu Hasaniya covers luxury sea-facing villas that overlook the water directly. Every sanitary fixture needs three things that agree with each other: something to fix to, a water supply, and a waste outlet at the right height.
Before you buy
When a swap isnot a swap.
Four things decide whether an installation is simple or needs extra work.
01
The waste sits at a different height
Every fixture has its waste outlet at a set height. If the new toilet takes a floor outlet and yours is in the wall, or the other way round, the installation means changing the waste and not just connecting it.
02
The unit hangs on the wall
A wall hung toilet or basin is not held by tiling. Each needs a steel frame fixed into the wall behind the finish to carry the whole load, and that is decided before the tiling, not after it.
03
The new unit is a different size
A new basin may cover the old fixing holes or fall short of them, and a new toilet may be longer and stand away from the wall. Checking the dimensions before buying saves a trip back to the shop.
04
There is no valve for it
A fixture installed with no angle valve of its own means any later repair stops water to the house. A proper installation includes a valve on each supply arriving at it.
This area
What setsthis area apart
Abu Hasaniya has very large villas on the direct waterfront, with walls exposed to severe humidity, salt and wind. Foundations and external walls are affected quickly by seawater and airborne salts, so ordinary metals corrode in months. When we install fixtures in a beachfront house, we must choose bolts and fittings made from salt-resistant alloys, and the waste line must slope correctly so foul water does not pool in pipes and cause odour or corrosion.
Abu Hasaniya sits in Mubarak Al-Kabeer governorate, an upscale villa area on the direct waterfront.
Sea-facing villas in Abu Hasaniya need regular inspection of exposed metal pipes because salt speeds corrosion.
In short
The fitting work.
Service
Sanitary fixture installation and connection
The fixtures
Basins, toilets, kitchen sinks, bidet sprays, utility sinks
Included
Fixing, water and waste connection, angle valve, silicone
The old units
Removed and taken out of the way before fitting
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we fit it
From measuringto running it.
The order here saves breaking, which is why we do not rush it.
We measure waste and supply
The height of the waste outlet and the positions of the supply pipes are measured against the new unit's own dimensions, before anything old comes off.
We remove and prepare
The old unit comes off, the old silicone is removed completely and the surface cleaned, because any residue stops new silicone bonding properly.
We fix and level it
The unit is fixed and levelled first, and connected second. Connecting before fixing means any later adjustment pulls on the joints and they start weeping later.
We connect, test and seal
Water and waste are connected, the unit is run, and every joint is checked under pressure. The silicone bead goes on last, once everything is proven dry.
Common questions
Questions about Sanitary fixture installation in Abu Hasaniya
Copper or stainless steel pipe outperforms ordinary iron. We use coated pipe or salt-resistant alloys. Plastic pipe also withstands salt, but must be heavy-duty international standard so it takes the pressure and heat.
Yes, we fit salt and water-resistant gasket between the fixture and wall to stop salt creeping behind fittings. Some large villas get a bypass valve or drain relief so the fixture does not suffer from pressure swings driven by wind and wave action.
Nearby areas
More areas for Sanitary fixture installation
Same service, in nearby areas.
Other services
Other services in Abu Hasaniya
Other work we do in the same area.
Back to Sanitary fixture installation