Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Sawaber
Kitchen flue installation in Sawaber, the large residential complex in central Kuwait City, means tall tower blocks where each unit has its own air exhaust line. Flats here are usually modern but the ducts are long and outlets cluster densely on the roof.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Sawaber is a complex of multi-storey tower blocks, and the extractor usually sits in an open kitchen or small kitchen next to a riser. Each flat's outlet emerges on the roof, but because outlets are numerous and close together, exhaust from one unit sometimes feeds into another. We ensure the duct itself is the right bore and the outlet has a cowl or mesh to stop dust or bird feathers blocking it.
Sawaber is in Kuwait governorate, a large residential complex in central Kuwait City with multiple tall towers.
Sawaber towers are tightly spaced, and the distance from the kitchen to the roof outlet is long, sometimes requiring a duct longer than practical limits.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Sawaber
Every month or two, because airflow in a long duct is sluggish so moisture builds up. We remove the outlet, clean it, and fit a better cowl that stops mould and makes maintenance easier.
It can happen if outlets are too close or there is a gap between them. We ensure each outlet discharges with enough force, and if needed we move yours higher or fit a baffle to block cross-odours.
Nearby areas
More areas for Kitchen flue installation
Same service, in nearby areas.
Other services
Other services in Sawaber
Other work we do in the same area.
Back to Kitchen flue installation