Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Rehab
Kitchen flue installation in Rehab is straightforward because most homes are family villas or spacious flats with large kitchens. The plan starts at the extractor itself, then we choose the shortest and best route for the duct so it exits the villa or flat cleanly.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Rehab is a quiet family area with spacious villas and large flats, and buildings are well-spaced. Villas in Rehab have generous kitchens and high ceilings, and the distance from kitchen to outside is relatively short, so flue installation is easier. Large flats have layouts that allow longer ducts with proper fall. Many homes in Rehab are newly built or recently renovated, so ceilings and walls are sound with no tangled old wiring, which lets us work smoothly.
Rehab is a quiet family area in Farwaniya governorate with spacious villas and large flats set with good spacing.
Most villas and flats in Rehab are new or recently upgraded, with high ceilings and sound walls, so flue installation requires minimal structural work.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Rehab
We choose the location based on the shortest distance from the extractor itself and the direction away from any outdoor seating or garden area. The aim is to shorten the duct and ensure hot vapour and grease do not drift toward outdoor sitting areas.
Yes, but the duct on the roof must be protected from sun and rain. We use strong metal ducting and a protective head cap so water does not enter and heat does not overly expand the tube.
Nearby areas
More areas for Kitchen flue installation
Same service, in nearby areas.
Other services
Other services in Rehab
Other work we do in the same area.
Back to Kitchen flue installation