Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Rai
Kitchen flue installation in Rai differs from other areas: kitchens here are often set deep indoors, ceilings are high, and buildings stand close to one another. The duct travels between your roof and a neighbour's in a narrow gap.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Rai is a mixed commercial and residential zone near The Avenues Mall and IKEA. Buildings here are mostly modern apartment towers with contemporary kitchens set under crossing AC lines, water pipes and electrics. When we install a flue, we measure the route from kitchen to roof opening exactly, and confirm the duct does not rub other tubes or block the air-conditioning supply.
Rai lies in Kuwait governorate, an urban district dense with modern apartment towers.
Most building roofs in Rai are shared among several flats, so the flue outlet must stay above the minimum clearance to avoid nuisance to other residents.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Rai
There is no other way, the duct must exit through the roof. We measure carefully that the void between ceilings and the final roof is wide enough, or we thread the tube through utility shafts if one exists.
Not if we install it correctly. We must confirm the duct does not block any return or supply vent for the AC system, and the flue needs thermal wrap if it runs beside cooling lines.
Other services
Other services in Rai
Other work we do in the same area.
Back to Kitchen flue installation