Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Jahra Industrial
Kitchen flue installation in Jahra Industrial takes place in factory canteens, staff kitchens and workshop break rooms across the zone. Jahra Industrial has diverse plants and craft workshops, with kitchens serving workers or connected to production itself, so the flue must handle stronger heat and fumes than a domestic kitchen.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Factories and workshops in Jahra Industrial have high ceilings and steel or reinforced concrete walls, with kitchens located in a corner or centre of the building. Industrial pipes need wider bore than domestic and a clear run from kitchen to outside with no obstacles. Some older workshops had no ventilation at all, so a new flue greatly improves worker safety and comfort. Regular maintenance matters more in factories than homes because of the volume of smoke and steam that builds up.
Jahra Industrial sits in Jahra governorate, a zone of diverse factories and production workshops.
Factory kitchens in Jahra Industrial are generally older than those in Mubarak plants, and most never had proper ventilation from the start.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Jahra Industrial
Yes, we can fit a small kitchenette with a simple flue. We visit and locate the best spot for the stove and pipe based on airflow and safety.
We first count how many stoves or burners are in use. If the process produces heavy heat, we fit larger ducts or may need multiple flues or an additional ceiling extractor to handle the load.
Other services
Other services in Jahra Industrial
Other work we do in the same area.
Back to Kitchen flue installation