Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Hateen
Kitchen flue installation in Hateen requires understanding the duct route and whether the outlet clears the building or terminates into the roof void. Hateen is a residential area in Hawalli with a mix of older and newer villas and flats, and older buildings sit shallower to the water table.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Hateen has a mix of flats and villas, flats usually have a main drainage stack on an external wall, and kitchens are laid out in various patterns. When we install, we check that the narrow duct is not too long and does not lose pressure, and that the seal is tight so water does not seep down the external wall. Villas in Hateen have larger kitchens but the duct may have to run above an existing drainage run.
Hateen is a residential area in Hawalli governorate, a mix of villas and apartment blocks, with older buildings featuring small flats and tight kitchens.
Most kitchens in Hateen have small or closed windows, so the flue must draw air from inside the flat without creating a negative pressure.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Hateen
Yes, but we fit a high-strength cap and securing collar so hot humid air does not crack the concrete. The cap sits raised above the roof level to keep rainwater out.
It can if the duct insulation is poor or the seal has small cracks. We test the seal on installation day and apply a moisture barrier around the external duct.
Nearby areas
More areas for Kitchen flue installation
Same service, in nearby areas.
Other services
Other services in Hateen
Other work we do in the same area.
Back to Kitchen flue installation