Plumbing and sanitary
Ramadan Drain CleaningKitchen flue installation in Fahad Al-Ahmad
Kitchen flue installation in Fahad Al-Ahmad starts by checking the wall cavity between the extractor and the outside. The area has mixed family houses of varying sizes, some older and some newly built, and many kitchens have tight space behind the hood.
Extraction symptoms
When the ductis the problem.
The hood runs loudly and the smell stays. That is where you start at the duct.
01
It runs and the smell stays
If the noise is strong but the air above the hob is not moving, the duct is either packed with grease, its outside termination is shut, or the hood was never ducted at all and is recirculating the air.
02
Steam gathering on the ceiling
Steam rising past the hood and collecting on the ceiling and the cupboards means the pull is weaker than the steam being produced. Usually the route is long, or it carries too many bends eating into the draw.
03
Grease dripping from the duct
Greasy drops coming off the joint above the hood mean grease has built up inside the duct, cooled and started to run back. That case needs the route cleaned, not just a new filter.
04
Outside air blows back in
Feeling hot air or dust coming in through the hood while it is off means the flap on the outside termination is broken or missing. That opening needs a flap that lifts with the extraction and falls shut after it.
This area
What setsthis area apart
Most houses in the area are medium-sized villas and flats built over different decades. Older kitchens sometimes have narrow or sharply bent ducts, so air does not exit efficiently. New ones need ducts of proper bore and a straight route to the outside. We check the wall cavity first to make sure the duct does not clog with steam and grease.
Fahad Al-Ahmad is in Ahmadi governorate, a mixed residential family area with varied construction age.
Most kitchens in the area vent air straight through the outer wall, not through a shared stack like tower blocks.
In short
The duct work.
Service
Kitchen flue and duct installation
Included
The duct route, joints, outside termination and its flap
Where it applies
Home and flat kitchens, and restaurant and shop kitchens
Harder cases
Flats with no outside wall, and long routes with bends
Hours
Daily, 6:00 in the morning to 12:00 midnight
How we route it
From the hood tothe outside wall.
The route is decided before a single component is bought.
We find the nearest way out
We work out the shortest route from the hood to the nearest outside wall or light well, because every extra length and every bend takes from the pull.
We size the duct
The duct is sized against the hood and the route. Narrowing it so it can pass behind a cupboard kills the draw, however strong the hood is.
We run it and seal the joints
The duct runs with as few bends as possible, and every joint is sealed so no steam or smell escapes into a false ceiling or behind the cupboards.
We fit the flap and test
The outside opening takes a flap that lifts with the extraction and closes after it, then the hood runs and we confirm the air above the hob really is moving.
Common questions
Questions about Kitchen flue installation in Fahad Al-Ahmad
Usually not. The duct inside is clogged with grease and steam. We open the duct from the hood itself, clean it, and check the bore and slope. If the duct is too narrow, we tell you it needs replacing.
It must be above nearby windows and doors, and not near the A/C unit or air intakes. We cut an opening of the right bore and fit a metal hood to stop rain and dust coming back in.
Other services
Other services in Fahad Al-Ahmad
Other work we do in the same area.
Back to Kitchen flue installation