Leak detection
Ramadan Drain CleaningWater leak detection in Zahraa
Water leak detection in Zahraa mostly involves apartment blocks and flats distributed throughout the neighbourhood. Zahraa is a residential area in Hawalli with multi-storey blocks fed by a central pump station. Pressurised lines leak constantly, draining water fast and pushing bills sky-high.
How to tell
Signs of a leak onthe supply.
Four signs that separate a supply leak from any other damp.
01
The meter turns with nothing on
Shut every tap, the washing machine and the heater, then go and look at the water meter. If the small dial is still turning while nothing is running, water is leaving between the meter and the house.
02
One tile joint stays wet
A joint between two tiles dries and comes back wet on its own, with no water anywhere near it. That joint is the weakest opening in the floor, so it is where water in the bedding surfaces first.
03
Paint lifts and plaster crumbles
Paint bubbling or plaster crumbling at roughly one height along a wall points to a pipe inside it, because the moisture spreads sideways along the line the pipe runs on.
04
Pressure dropped upstairs only
If the pressure drops on the top floor while the ground floor is normal, the loss is usually on the riser. Water leaving it takes away whatever reaches the furthest point in the network.
This area
What setsthis area apart
Zahraa's blocks are mostly five to seven storeys, with main lines entering from the street and rising through internal metal or plastic stacks. Each building has a main meter before lines branch to individual units. Leaks can occur in the block's main line or within a unit's branch. We check the main meter and visible branches first, then listen for sounds from walls and floors. If moisture appears on the ceiling of the flat below, the leak is definitely above.
Zahraa sits in Hawalli governorate, a residential area of tall apartment blocks served by main water lines from a central pump station.
Tall blocks in Zahraa have dual main risers starting from the street and rising through each floor, with pressure increasing at higher levels.
Service card
The service, in a line.
Service
Water leak detection on the house supply
Where it applies
Houses, flats, blocks, complexes and shops
Lines covered
Cold, hot, tank feed and pump lines
Method
Valve isolation, a meter watch, and listening at fittings
What you get
A marked point on the floor and the line it sits on
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
How we get to thepoint.
Four steps, and the order is what keeps the job short.
We confirm there is a loss
We shut everything in the house that uses water, take a meter reading, then take it again. If the reading has moved, the loss is real.
We split inside from outside
We close the valve feeding the house and read again. That says whether the water is going inside the internal network or on the run coming from the tank or the meter.
We narrow it to one line
We close the bathroom, kitchen and hot water valves one at a time. The one that stops the reading is the line that is leaking.
We listen and mark the spot
On the line we found, we listen at its fittings and over the floor above it, then mark the loudest point on the tile in front of you.
Common questions
Questions about Water leak detection in Zahraa
We ask you to close all taps and appliances in your unit, then we go down to check the building's main meter. If it moves, the leak is yours. Then we go to the eighth floor and listen, checking pipes and walls for moisture.
A main line leak affects all units in the block and may show water in the passage or street. Your unit line leak affects only you. We check the main meter first to determine the difference.
Nearby areas
More areas for Water leak detection
Same service, in nearby areas.
Other services
Other services in Zahraa
Other work we do in the same area.