How to tell
Signs of a leak onthe supply.
Four signs that separate a supply leak from any other damp.
01
The meter turns with nothing on
Shut every tap, the washing machine and the heater, then go and look at the water meter. If the small dial is still turning while nothing is running, water is leaving between the meter and the house.
02
One tile joint stays wet
A joint between two tiles dries and comes back wet on its own, with no water anywhere near it. That joint is the weakest opening in the floor, so it is where water in the bedding surfaces first.
03
Paint lifts and plaster crumbles
Paint bubbling or plaster crumbling at roughly one height along a wall points to a pipe inside it, because the moisture spreads sideways along the line the pipe runs on.
04
Pressure dropped upstairs only
If the pressure drops on the top floor while the ground floor is normal, the loss is usually on the riser. Water leaving it takes away whatever reaches the furthest point in the network.
This area
What setsthis area apart
Qibla has apartment blocks, hotels and shops packed tightly together, and the main water line is shared among many buildings. Each building has its own branch from the main line, and the leak could be in the shared line under the road or in the building's own branch. We search by listening and pressure to narrow the focus, then mark the location clearly in front of you before any digging or breaking.
Qibla sits in Kuwait governorate near Gulf Road and contains dense residential and commercial buildings.
Buildings in Qibla share one main water line, so even a small leak in it affects multiple buildings at once.
Service card
The service, in a line.
Service
Water leak detection on the house supply
Where it applies
Houses, flats, blocks, complexes and shops
Lines covered
Cold, hot, tank feed and pump lines
Method
Valve isolation, a meter watch, and listening at fittings
What you get
A marked point on the floor and the line it sits on
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
How we get to thepoint.
Four steps, and the order is what keeps the job short.
We confirm there is a loss
We shut everything in the house that uses water, take a meter reading, then take it again. If the reading has moved, the loss is real.
We split inside from outside
We close the valve feeding the house and read again. That says whether the water is going inside the internal network or on the run coming from the tank or the meter.
We narrow it to one line
We close the bathroom, kitchen and hot water valves one at a time. The one that stops the reading is the line that is leaking.
We listen and mark the spot
On the line we found, we listen at its fittings and over the floor above it, then mark the loudest point on the tile in front of you.
Common questions
Questions about Water leak detection in Qibla
We check the pressure in the main line and compare it to the pressure inside the building. If the difference is big, the leak is in the shared line under the road.
Yes, one main line feeds all the buildings, so any leak in it lowers pressure everywhere. We see the signs quickly if other buildings complain of weak pressure.
Nearby areas
More areas for Water leak detection
Same service, in nearby areas.
Other services
Other services in Qibla
Other work we do in the same area.