Leak detection
Ramadan Drain CleaningWater leak detection in Maqwa
Water leak detection in Maqwa focuses on mixed industrial and residential areas, where lines run long distances underground and may sit under heavy house foundations. Leaks in Maqwa often start as low water pressure or increased dampness around the foundation.
How to tell
Signs of a leak onthe supply.
Four signs that separate a supply leak from any other damp.
01
The meter turns with nothing on
Shut every tap, the washing machine and the heater, then go and look at the water meter. If the small dial is still turning while nothing is running, water is leaving between the meter and the house.
02
One tile joint stays wet
A joint between two tiles dries and comes back wet on its own, with no water anywhere near it. That joint is the weakest opening in the floor, so it is where water in the bedding surfaces first.
03
Paint lifts and plaster crumbles
Paint bubbling or plaster crumbling at roughly one height along a wall points to a pipe inside it, because the moisture spreads sideways along the line the pipe runs on.
04
Pressure dropped upstairs only
If the pressure drops on the top floor while the ground floor is normal, the loss is usually on the riser. Water leaving it takes away whatever reaches the furthest point in the network.
This area
What setsthis area apart
Maqwa is near the Kuwait Oil Company fields and has older houses next to newer buildings, with narrow passages between plots and uneven ground levels. The main line sometimes runs under more than one plot before reaching a house, and concrete foundations may be deep. If there is a leak in Maqwa's main line, we may need to dig in several places to trace the water, so we use rods and a torch to pinpoint the location exactly before digging.
Maqwa sits in Ahmadi governorate, a mixed industrial and residential area near oil fields.
Land levels in Maqwa vary significantly, so supply lines may sit at very different depths from one plot to another.
Service card
The service, in a line.
Service
Water leak detection on the house supply
Where it applies
Houses, flats, blocks, complexes and shops
Lines covered
Cold, hot, tank feed and pump lines
Method
Valve isolation, a meter watch, and listening at fittings
What you get
A marked point on the floor and the line it sits on
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
How we get to thepoint.
Four steps, and the order is what keeps the job short.
We confirm there is a loss
We shut everything in the house that uses water, take a meter reading, then take it again. If the reading has moved, the loss is real.
We split inside from outside
We close the valve feeding the house and read again. That says whether the water is going inside the internal network or on the run coming from the tank or the meter.
We narrow it to one line
We close the bathroom, kitchen and hot water valves one at a time. The one that stops the reading is the line that is leaking.
We listen and mark the spot
On the line we found, we listen at its fittings and over the floor above it, then mark the loudest point on the tile in front of you.
Common questions
Questions about Water leak detection in Maqwa
We look for damp patches or areas where grass is greener than elsewhere. We use rods to tap the ground and listen for voids or sounds. Then we pinpoint the exact location before digging any holes.
Old houses in Maqwa may have old lines, but not every old line leaks. We have to measure, tap and search carefully to be sure. Sometimes the problem is water pressure itself or the tap setup.
Other services
Other services in Maqwa
Other work we do in the same area.