Leak detection
Ramadan Drain CleaningWater leak detection in Anjafa
Water leak detection in Anjafa usually starts with a bill that jumped without an obvious reason. Anjafa is a residential area in Hawalli, and its flats are two and three storeys, with supply lines running through walls and floors from the rooftop tank to each unit. The line stays pressurised all day, so any leak in it keeps running and seeps through the finishes.
How to tell
Signs of a leak onthe supply.
Four signs that separate a supply leak from any other damp.
01
The meter turns with nothing on
Shut every tap, the washing machine and the heater, then go and look at the water meter. If the small dial is still turning while nothing is running, water is leaving between the meter and the house.
02
One tile joint stays wet
A joint between two tiles dries and comes back wet on its own, with no water anywhere near it. That joint is the weakest opening in the floor, so it is where water in the bedding surfaces first.
03
Paint lifts and plaster crumbles
Paint bubbling or plaster crumbling at roughly one height along a wall points to a pipe inside it, because the moisture spreads sideways along the line the pipe runs on.
04
Pressure dropped upstairs only
If the pressure drops on the top floor while the ground floor is normal, the loss is usually on the riser. Water leaving it takes away whatever reaches the furthest point in the network.
This area
What setsthis area apart
Flats in Anjafa are older buildings, and the main lines run from the meter box on the ground or the outer wall, then branch to each unit. Most flats have patched maintenance rather than original pipework, so the leak could be from an old joint in the wall or under bathroom tiles. We shut off the line from the tank and pressure-test it until we pinpoint exactly where the problem is before any breaking or drilling starts.
Anjafa is a residential area in Hawalli governorate, made up of medium-rise apartment blocks and flats.
Most water lines in Anjafa are buried in walls and floors, not exposed on the roof like newer areas.
Service card
The service, in a line.
Service
Water leak detection on the house supply
Where it applies
Houses, flats, blocks, complexes and shops
Lines covered
Cold, hot, tank feed and pump lines
Method
Valve isolation, a meter watch, and listening at fittings
What you get
A marked point on the floor and the line it sits on
Hours
Daily, 6:00 in the morning to 12:00 midnight
The method
How we get to thepoint.
Four steps, and the order is what keeps the job short.
We confirm there is a loss
We shut everything in the house that uses water, take a meter reading, then take it again. If the reading has moved, the loss is real.
We split inside from outside
We close the valve feeding the house and read again. That says whether the water is going inside the internal network or on the run coming from the tank or the meter.
We narrow it to one line
We close the bathroom, kitchen and hot water valves one at a time. The one that stops the reading is the line that is leaking.
We listen and mark the spot
On the line we found, we listen at its fittings and over the floor above it, then mark the loudest point on the tile in front of you.
Common questions
Questions about Water leak detection in Anjafa
We pressure-test the line until something shows up on the meter or the bill, and the tank won't lose water if the line is isolated from it. If the tank itself is leaking, we see it from outside on the roof.
First we pinpoint it exactly using pressure and marking fluid. Then you decide whether to break the tiles or route new lines. We mark the exact spot before any demolition starts.
Nearby areas
More areas for Water leak detection
Same service, in nearby areas.
Other services
Other services in Anjafa
Other work we do in the same area.