Commercial contracts
Ramadan Drain CleaningBuilding and complex maintenance in Rai Industrial
The drainage network in Rai Industrial serves diverse industrial and commercial buildings on separate lines and multiple inspection chambers. Rai Industrial is complex because each factory or shop sits on its own line and some buildings have multiple storeys and several drain outlets.
Signs across a block
Where a block showsits faults.
A block does not complain from one place. These are the spots that show it first.
01
One flat complains and the rest are fine
When one flat has water coming back and the rest drain normally, the fault sits in its own branch or where that branch joins the shared run, not in the shared run itself.
02
Water standing in the car park
A car park gully sits below street level, so any narrowing shows at once as a pool on the concrete. The cause we see most is grit and dust carried down by car washing and settled in the pot.
03
The tank water changes in summer
A roof tank sitting in the sun heats up, the water standing in it changes in taste and smell, and sediment can settle at the bottom. Residents complain about the water rather than the drains, and the cause is above them.
This area
What setsthis area apart
Rai Industrial has light and heavy factories, warehouses, and mixed-use commercial buildings. Each building has an underground drain point and some have separate lines for wash-down water or toilets. The car park between buildings is wide and the ground is crisscrossed with distribution lines under the asphalt. The main riser feeds a central inspection chamber near the Gulf Road, and its low points are prone to sediment buildup. We inspect the lines carefully because some factories have oil or grease that blocks pipes.
Rai Industrial sits in Farwaniya governorate, a mixed industrial and commercial area on a unified drainage network.
Drain lines in Rai Industrial are branched and separate for each building, and chambers under the asphalt need regular checks for accumulated oils and grease.
The work in short
What we cover ina block.
Service
Water and drainage network upkeep for a whole building
Where it applies
Residential blocks, complexes and buildings with several entrances
The points
Inspection chambers, manholes, car park gullies, roof tanks and pumps
Method
Chambers opened in order, drain rods, and a tanker when suction is needed
Coverage
All six governorates and the areas inside them
The round
From the roofto the car park.
We start at the top and work down, because what happens above shows up below.
We start at the tank and pump
We open the tank, look at the water and any sediment in the base, and watch the pump while it runs, because weak supply in the flats usually starts here and not at the tap.
We move to the vertical stacks
The stack collecting the bathrooms of the flats above one another reads from the access points and the landing gullies. We listen for water falling at its normal pace, or hesitating before it goes.
We open the yard chambers in order
We open from the chamber nearest the building and move towards the outlet, reading the level in each channel. A full chamber followed by an empty one puts the stoppage exactly between the two.
We finish at the car park
We lift the car park gully grating, clear what has settled in the pot, and check the outlet still sits above the standing water line, because that seal is what keeps odour out of the car park.
Common questions
Questions about Building and complex maintenance in Rai Industrial
Yes, oil blocks pipes quickly. We inspect factory lines more frequently and use stronger cleaning methods if needed.
Yes, each line needs separate inspection and cleaning. We open the inspection chamber for each line and make sure it flows properly.
Nearby areas
More areas for Building and complex maintenance
Same service, in nearby areas.
Other services
Other services in Rai Industrial
Other work we do in the same area.
Back to Building and complex maintenance